Jason Askins - Haas Basic Lathe Operator Feedback
Brendan,
Passed the Lathe operator’s certification with very little experience with the Haas control.
He was able to start the program safely after some instruction.
-Ernie Simmons
Haas Basic Lathe Operator
Below is the Basic Lathe Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Brendan Kirk - Haas Basic Lathe Operator Feedback
Brendan,
Passed the Lathe operator’s certification.
He knew the control and features of the machine and was able to start the program safely.
-Ernie Simmons
Sean Saki - Haas Basic Lathe Operator Feedback
Sean,
Passed the lathe operator’s certification.
He knew the control and features of the machine and was able to start the program safely.
-Ernie Simmons
Tom Ryan - Haas Basic Lathe Operator Feedback
Tom,
Passed the lathe operator’s certification with flying colors.
He knew the control and features of the machine and was able to start the program safely.
-Ernie Simmons
Mathias Conner - Haas Basic Lathe Operator Feedback
Mathias,
Passed the lathe operator’s certification with flying colors.
He knew the control and features of the machine and was able to start the program safely.
-Ernie Simmons
Victoria Pace - Haas Basic Lathe Operator Feedback
Victoria,
Passed the Lathe operator’s certification with flying colors.
She knew the control and features of the machine well and was able to start the program safely.
I could tell she was a little nervous about running the program but was more comfortable after a little practice.
-Ernie Simmons