Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

[email protected] - HAAS Mill Operator Feedback

Richard was very familiar with the Haas control and was able to explain the functions of all of the buttons.

He had no problem selecting the correct material and loaded the stock in the vise with the correct torque.

He used both hands when using single block and verified the distance to go at 25% rapid.

He was a little unsure of where the interlocks were on the doors.

Richard did a good job taking the final with the limited time he has had working on an actual machine.

 

Ernie Simmons

Submitted by hst_api_user on Mon, 02/24/2020 - 10:40

[email protected] - HAAS Mill Operator Feedback

John did not pass the first time he tried to taking the final because he did not understand how to use the distance to go screen. He waited to press feed hold after the machine had already completed that block.

John spent some time practicing on a machine in R & D and was able to pass the final the second time.

He was able to explain the functions of all of the buttons. He was a little unsure of where some of the buttons were on the pendent.

He had no problem selecting the correct material and loaded the stock in the vise with the correct torque.

Submitted by hst_api_user on Mon, 02/24/2020 - 11:02

[email protected] - HAAS Mill Operator Feedback

Mike was very familiar with the Haas control and was able to explain the functions of all of the buttons.

He had no problem selecting the correct material and loaded the stock in the vise with the correct torque.

He used both hands when using single block and verified the distance to go at 25% rapid.

Mike did a good job taking the final with the limited time he has had working on an actual machine.

 

Ernie Simmons

Submitted by hst_api_user on Mon, 02/24/2020 - 11:09