Haas Basic Mill Operator
Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Intro Video:
Final Video:
[email protected] - HAAS Mill Operator Feedback
[email protected] - HAAS Mill Operator Feedback
[email protected] - HAAS Mill Operator Feedback
a little hesitation on tooling knowledge, but understood the machine and the controler to successfully run programs and continue production.
[email protected] - HAAS Mill Operator Feedback
Jeffrey did well on this hands on test. Did a really good job running the part & seems to know his way around the control panel.
Total Points Available: 600
Total Points Received: 582.5
Final %: 97%
[email protected] - HAAS Mill Operator Feedback
Jim did very good on the hands on test. He mainly runs Haas lathe, but did really good navigating the control.
Total Points Available: 600
Total Points Received: 592.5
Final %: 99%
[email protected] - HAAS Mill Operator Feedback
[email protected] - HAAS Mill Operator Feedback
Jerod did well on the hands on test. He is a little new to CNC, but did well on the test.
Total Points Available: 600
Total Point Received: 560
Fianl %: 93%
[email protected] - HAAS Mill Operator Feedback
Andrew did well on the test. Andrew has more of a welding back round, but did well on the control.
Total Ponts Available: 600
Total Points Received: 545
Final %: 91%
[email protected] - HAAS Mill Operator Feedback
Stephen did well on the hands on test. Had some trouble with loading the material on the saw cut sides, but did well at moving around the control.
Total Points Available: 600
Total Points Received: 575
Final %: 96%