Haas Basic Mill Operator
Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Intro Video:
Final Video:
Elijah Pate - Haas Basic Mill Operator Feedback
Liam O´Connor - Haas Basic Mill Operator Feedback
This student cut the raw material using an instructor-created setup sheet and ensured the proper tools were in the correct pockets. This student also performed tool offsets and work offsets using the HAAS WIPS system. This student then machined a part requiring four operations and two work offset procedures.
Adan Navarro - Haas Basic Mill Operator Feedback
This student cut the raw material using an instructor-created setup sheet and ensured the proper tools were in the correct pockets. This student also performed tool offsets and work offsets using the HAAS WIPS system. This student then machined a part requiring four operations and two work offset procedures.
Jay Alameda - Haas Basic Mill Operator Feedback
Miguel De Jesus Gil - Haas Basic Mill Operator Feedback
This student cut the raw material using an instructor-created setup sheet and ensured the proper tools were in the correct pockets. This student also performed tool offsets and work offsets using the HAAS WIPS system. This student then machined a part requiring four operations and two work offset procedures.
Diego montano - Haas Basic Mill Operator Feedback
This student cut the raw material using an instructor-created setup sheet and ensured the proper tools were in the correct pockets. This student also performed tool offsets and work offsets using the HAAS WIPS system. This student then machined a part requiring four operations and two work offset procedures.
Conner Holman - Haas Basic Mill Operator Feedback
Connor excelled on his hands-on test.