Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

ARMIN BAONG - Haas Basic Mill Operator Feedback

Student has passed the test, he was not familiar with the Haas controller as he has been working most of the time on Okuam and DMG controls.

He has found the Haas controller very user frindly.

Safety Apparel on the day was all good.

Machine Orientation left side, back of the machine, right side odf the machine, front of the machine and inside the machine, he done realy well. This was done on a VF-4SS.

Going over the control panel was done on a VF-4SS.

Loading and unloading of parts and running test cuts was done on a Desktop Mill.

 

Submitted by hst_api_user on Thu, 04/04/2024 - 14:24