Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

Arsen Gulbankian - Haas Basic Mill Operator Feedback

Student struggled to identify the various parts of the machine. In correct terminology and identification.

Did not choose appropriate raw material.

Did not clean off table and vice for material installation.

Did not read and interpret comments in the code to help with material installation and tool selection.

Exam was cut short due to an inability to move forward safely.

Student should try again after receiving further exposure to the machine.

Submitted by hst_api_user on Tue, 12/20/2022 - 05:15