| Topics to Cover and Questions to ask: |
Place check mark OR OK |
| |
|
| Safety Apparel |
|
| Safety Glasses |
ok |
| Appropriately dressed for a Machine Shop environment |
ok |
| |
|
| Machine Orientation |
|
| Left Side of Machine |
|
| Chip Chute |
ok |
| Coolant Return |
ok |
| Coolant Tank |
ok |
| What in the Coolant Tank are you checking for? (Levels & Concentration) |
ok |
| How often should the coolant be checked? (Daily) |
ok |
| |
|
| Back of Machine |
|
| Electric Cabinet |
ok |
| Power ON/OFF Switch |
ok |
| How often should you go into the Electric Cabinet? (Never) |
ok |
| |
|
| Right Side of Machine |
|
| Lube & Air Cabinet |
ok |
| Air Pressure Gage |
ok |
| |
|
| Front of Machine |
|
| Control Pendant |
ok |
| Wash Down Hose |
ok |
| Air Gun |
ok |
| Why does the macine have 'Door Interlocks'? |
ok |
| |
|
| Inside the Machine |
|
| Machine Table |
ok |
| Vise/Fixture |
ok |
| Spindle |
ok |
| Tool Release Button |
ok |
| Chip Auger |
ok |
| Coolant Ring |
ok |
| Tool Changer Arm |
ok |
| |
|
| Raw Material |
|
| Can the Student confirm that the material chosen is the correct material for this job? |
ok |
| |
|
| |
|
| Control Panel |
|
| E-Stop |
|
| What happens when you press E-stop? (Stops all movement & alarms the machine) |
ok |
| Have the Student show you that they can engage the E-Stop button |
ok |
| Reset |
|
| What happens when you press Reset? (Stops all movement & Resets the program) |
ok |
| Feed Hold |
|
| What happens when you press Feed Hold? (Stops Axis movement, Spindle remains on, Pause Program) |
ok |
| Cycle Start |
|
| What happens when you press Cycle Start? (Start Axis movement, Starts Spindle, Starts Program) |
ok |
| Single Block |
|
| What happens when you press Single Block? (Runs program one line at a time.) |
ok |
| Rapid Overrides |
|
| From the video, What rapid over % is recommend? (25%) |
ok |
| Feed & Spindle Overrides |
|
| From the video, When should you a adjust the Feed or Spindle Overrides? (Never) |
ok |
| |
|
| Loading Raw Material |
|
| Opening Vise |
ok |
| Used air gun to clean jaws? |
ok |
| Part set in jaws correctly? |
ok |
| Part push to stop correctly? |
ok |
| Closed Vise and tighten sufficiently |
ok |
| Removed Vise Handle |
ok |
| |
|
| Running Part Program |
|
| Closed the front doors to machine |
ok |
| Press Cycle Start |
ok |
| Fingers on Cycle Start & Feed Hold |
ok |
| |
|
| Remove Part & Load Raw Material Again |
|
| Did operator open doors & use air gun to clean part? |
ok |
| Opened vise |
ok |
| Removed part & cleaned with air gun? |
ok |
| Used air gun to clean jaws on vise? |
ok |
| New raw material is set in jaws correctly? |
ok |
| Closed Vise and tighten sufficiently |
ok |
| Removed Vise Handle |
ok |
| |
|
