Haas Basic Lathe Operator
Below is the Basic Lathe Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Gregory Sword - Haas Basic Lathe Operator Feedback
Gregory Sword - Haas Basic Lathe Operator Feedback
Duane Ehrlich - Haas Basic Lathe Operator Feedback
Tristan Moss - Haas Basic Lathe Operator Feedback
J. McNeill
Radik Gradinarski - Haas Basic Lathe Operator Feedback
Radik,
Knows the has control very well and had no problem picking out the stock to be used. Hasn’t worked on machine but was very exited to learn now to load the part in the chuck and how to use the distance to go positions display to start the program safely. After practice using the distance to go he has it down where he can start the program safely to verify the offsets are correct. He follows instructions well and would make a great operator with some more practice.
He passes the hands on final with little previse experience.
-Ernie Simmons
Kevin Riggs - Haas Basic Lathe Operator Feedback
Student successfully loaded a program, tooling, and workpiece. Checked coolant level, no adjustment required. Initial run with single block and rapid reduced to prove program, and part. Ran a second part at production speeds creating a part in specification. Student demonstrated caution and care while operating Haas ST10.
Panagiotis Maniadis - Haas Basic Lathe Operator Feedback
Panagiotis,
Hasn’t worked on lathe machine but was very exited to learn now to load the part in the chuck and how to use the distance to go positions display to start the program safely. After practice using the distance to go he has it down where he can start the program safely to verify the offsets are correct. He follows instructions well and would make a great operator with some more practice.
He passes the hands on final with little previse experience.
-Ernie Simmons
Emmit Patterson - Haas Basic Lathe Operator Feedback
Student successfully loaded a program, tooling, and workpiece. Checked coolant level, no adjustment required. Initial run with single block and rapid reduced to prove program, and part. Ran a second part at production speeds creating a part in specification. Student demonstrated caution and care while operating Haas ST10.
Orville Collins - Haas Basic Lathe Operator Feedback
Orville,
Knows the control and machine features extensively. He wasn't as comfortable with running the lathe as he was the mill but did great loading the part in the chuck, used the distance too go position to start the new program safely. He would be able to run production on the mill with no problems.
Orville passes the lathe operator hands on final with flying colors.
-Ernie