Haas Basic Lathe Operator
Below is the Basic Lathe Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
[email protected] Haas Basic Lathe Operator feedback
[email protected] Haas Basic Lathe Operator feedback
[email protected] Haas Basic Lathe Operator feedback
[email protected] Haas Basic Lathe Operator feedback
Alastair Brennan - Haas Basic Lathe Operator Feedback
Alastair pick the correct material from the drawing very quickly and was able to load the part in the chuck and start the machine safely using single block, distance to go at 5% rapid.
He made sure the chuck jaws were clean before loading the part for the second operation.
Jimmy Nguyen - Haas Basic Lathe Operator Feedback
Jimmy was able to load the part in the chuck and start the machine safely using single block, distance to go at 5% rapid.
He made sure the chuck jaws were clean before loading the part for the second operation.
Johnny Estrada - Haas Basic Lathe Operator Feedback
Johnny pick the correct material from the drawing very quickly. He loaded the stock in the chuck against the stop.
He was able to start the program safely using single block and distance to go.
Michelle Norman - Haas Basic Lathe Operator Feedback
Michelle knew all the buttons of the control but you can tell that she has no experience running parts on a machine. She loaded the part in chuck against the stop.
She use single block and distance to go to start the first tool safely.