Haas Basic Lathe Operator
Below is the Basic Lathe Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
[email protected] Haas Basic Lathe Operator feedback
Karla Penney - Haas Basic Lathe Operator Feedback
Karla knows the control very well and has a good understanding of how to use single block and the distance to go positions screen too safely start a program that she has not ran before.
She checked the chuck jaws indicator to make sure that the part is clamped in the chuck correctly.
She has very little experience loading a part in a chuck but did a good job making sure that the jaws were clean and that the part was against the stop when closing the chuck.