Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

Eloy Cavazos - Haas Basic Mill Operator Feedback

Student successfully loaded a program, tooling, and workpiece.  Checked coolant level, no adjustment required.  Initial run with single block and rapid reduced to prove program, and part.  Ran a second part at production speeds creating a part in specification.  Student demonstrated caution and care while operating Haas VF1.

Submitted by [email protected] on Fri, 01/20/2023 - 06:51