Scott Dudkiewicz - Haas Basic Mill Operator Feedback
Scott is a Teacher at Erie High School.
Hands on Test was completed by Corey Drebot from HFO Pittsburgh.
Scott will be helping to perform the hands-on test out of Erie High School.
Haas Basic Mill Operator
Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Intro Video:
Final Video:
Ali Al-thabhawi - Haas Basic Mill Operator Feedback
Ali-AL-thabhawi is a student at Erie High School.
Hands on Test was completed by Greg Wetzel at Erie High School.