Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

Triston Hatchell - Haas Basic Mill Operator Feedback

Triston Hatchell-

Triston was wearing safety glasses and the correct apparel for running a machine.

He was able to show me the electrical, air and lube cabinets and knows that he should not open ether of them.

He did not know air pressure range from the video he looked up the values in his notes.

He knew that the machine coolant level should be check at the beginning of every shift.

Used calipers to pick the material but selected the steel plate instead of the aluminum stock stated on the part drawing.

Submitted by hst_api_user on Thu, 10/15/2020 - 13:06

Marco Martinez - Haas Basic Mill Operator Feedback

Marco Martinez-

Marco was wearing safety glasses and the correct apparel for running a machine.

He was able to show me the electrical, air and lube cabinets and knows that he should not open ether of them.

He did know air pressure range from the video.

He knew that the machine coolant level should be check at the beginning of every shift.

Used calipers to pick the material but selected the steel plate instead of the aluminum stock stated on the part drawing.

Submitted by hst_api_user on Thu, 10/15/2020 - 12:52