Haas Basic Mill Operator
Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:
Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.
- Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
- To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
- Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
- You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
- Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
- Best of luck on your journey through the Haas Certification Program!
Intro Video:
Final Video:
Arda Buyuksan - Haas Basic Mill Operator Feedback
Arda Buyuksan-
Arda was wearing safety glasses and the correct apparel for running a machine.
He was able to show me the electrical, air and lube cabinets and knows that he should not open ether of them.
He did not know air pressure range from the video but gave me an acceptable range that is shown on the side of the machine (80-120 / 85-110).
He knew that the machine coolant level should be check at the beginning of every shift.
Used scale to pick the correct material stated on the part drawing.
Brad Williams - Haas Basic Mill Operator Feedback
Brad Williams-
Brad was wearing safety glasses and the correct apparel for running a machine.
He was able to show me the electrical, air and lube cabinets and knows that he should not open ether of them.
He did not know air pressure range from the video but gave me the range shown on the stick on the side of the machine that is slightly different from the values in the video (80-120 / 85-110).
He knew that the machine coolant level should be check at the beginning of every shift.