Anthony did well on the hands-on test.  

Points avaiable: 600

Points Received: 560

Final %: 93%

• Identified everything quickly and with more than enough knowledge
• Used graphics mode to ensure it was the correct part
• used single block to run part (Being his first part0
• inspected parts and identified any errors

• Was able to identify all parts of the machine except the air shut off valve
• Cleaned vise and put part in properly
• Was able to measure and identify all measuremeents in tolerance

• Identified all parts of machien while proving to have additional knowledge
• clean vise and put part in properly
• measured part correctly
• cleaned vise and removed all parts from vise

• Displayed a basic understading of content
  • Had some issues identifing single block and optional stop
• Properly loaded part into Vise
• Measured part and properly identified sections that were in/out of tolerance
• Cleaned and removed everything from machine

Excelled in all sections of the testing, and effectively operated the machine through the parts operations. 

Excelled in all sections of the testing, and effectively operated the machine through the parts operations. 

Student had slight hesitation on a few of the machine components, but understood the most important componentry. Struggled on the tooling testing side and should invest time in gaining more knowledge towards tooling. Successfully ran the machine operation in an effective and safe manner, while displaying knowledge in GD&T.

successfully completed checklist 2/13/20