Back

Haas Basic Mill Operator

Below is the Basic Mill Operator Course Curriculum. Please review the following points, prior to starting this course:

Courses are presented one chapter at a time, with individual topics presented in video format. Each video is followed by a corresponding quiz to test your understanding of the topic presented. You must pass the quiz for each topic to gain access to the next topic.

  • Start by viewing the Introduction to Haas Certification video below (there is no corresponding quiz)
  • To begin your course, select the first topic in Chapter 1, watch the video, and take the quiz
  • Once you have clicked the Take Quiz button, you will have 15 minutes to complete the quiz
  • You must score 100% on each quiz to pass, and gain access to the next topic; if you fail a quiz, you must retake it until you pass
  • Quizzes are straightforward, and based solely on the content presented in the corresponding video – there are no trick questions
  • Best of luck on your journey through the Haas Certification Program!
Intro Video: 

 

 

 

Final Video: 

 

[email protected] - HAAS Mill Operator Feedback

Scott was appropriately dressed for a machine shop environment. He was able to identify the following parts chip chute, coolant tank, electric cabinet, power switch, air pressure gauge, control pendant, air gun, spindle, auger, etc.

Scott confirmed the raw material that was chosen was the correct material for the job. He understands the functions and differences between the E-Stop, Reset, Feed Hold, Cycle Start and Single Block buttons. Scott was able to successfully load the raw material, run the part program and remove the part.

 

Submitted by hst_api_user on Mon, 12/02/2019 - 08:21